Re: [Rpcemu] Full screen display

In article <VI1PR08MB2846A7C2CD95E5C232AA3DB8D3729@VI1PR08MB2846.eurprd08.prod.outlook.com>,
David Gee <dr.david.gee@outlook.com> wrote:
> Which version of RPCEmu are you using? This used to be a problem with
> the 0.8.x series but I thought it had been avoided in the 0.9.x
> series, which uses Qt rather than Allegro to produce the interface. I
> don't think I've encountered it recently, but then on the HP laptop
> that I run Linux on, I start RPCEmu up in full-screen mode and run it
> at a lower resolution than full-screen (which, with a native
> resolution of 1920 x 1089, results in text that is too small to read
> comfortably in RO).

Version is 0.9.3.

> It would be surprising if two completely different methods of
> generating the UI produced the same error.

I seem to remember the Allegro versions didn't allow me to use full
screen properly at all. That's why I still had the MDF with 1044 height
in the list.

Regards,
Frank


_______________________________________________
RPCEmu mailing list
RPCEmu@riscos.info
http://www.riscos.info/cgi-bin/mailman/listinfo/rpcemu