Re: [Rpcemu] 0.8.10/5.20: MIPS readout oddity

In message <20130822182907.GD31223@spod.org>
Peter Howkins <rpcemu.howkins@marutan.net> wrote:

> On Thu, Aug 22, 2013 at 08:18:16AM +0100, george greenfield wrote:
>> In message <7b84d77e53.old_coaster@old_coaster.yahoo..co.uk>
>> Tony Moore <old_coaster@yahoo.co.uk> wrote:
>>
>> > On 21 Aug 2013, Peter Howkins <rpcemu.howkins@marutan.net> wrote:
>> >
>> > [snip]
>> >
>> >> If you're running on Vista or 7 and you used the windows installer,
>> >> don't check Program Files/RPCEmu/rpc.cfg but Users/<your
>> >> userame>/AppData/Local/VirtualStore/Program Files/RPCEmu/rpc.cfg
>> >
>
> George, can you confirm whether your config file issue was resolved by
> comparing this other file.

Hi Peter

I didn't use the Windows installer (I installed direct from the zips),
so not sure whether the
'Users/<youruserame>/AppData/Local/VirtualStore/Program
Files/RPCEmu/rpc.cfg' file will actually be relevant....
>
> As to your new issue, try not using 256MB of RAM, but a lower value.
> There's some interesting issues with risc os and that much ram on real
> hardware, and I'm wondering if similar occurs when emulated.

Reducing RAM to 128MB via Settings-Configure-RAM seems to have helped;
0.8.10/5.20 recompiler is now up and running (hurrah) and networking
is back up too (in fact I'm sending this post from it). This
installation is in OS (C:)>Program Files>RPCEmu0810-520>rpcemu520,
which was created from scratch i.e. was not in use for an earlier
RPCEmu version. A quick check of rpc.cfg in the rpcemu520 folder shows
no change in the base settings, i.e., still showing ARM610 and 32MB
RAM, for instance. Any suggestions where I should look for the real
McCoy?

George

_______________________________________________
Rpcemu mailing list
Rpcemu@riscos.info
http://www.riscos.info/cgi-bin/mailman/listinfo/rpcemu